User Manual
Table Of Contents
- Contents
- Introduction
- IMPORTANT SAFETY INSTRUCTIONS
- Specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
- STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
- STEP 4 - Determine wall-mount location
- STEP 5 - Option 1: Installing on a wood stud wall
- STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 6 - Attach your TV to the wall mount
- STEP 7 - Adjusting the tilt angle
- Removing the TV from the wall mount
- LIFETIME LIMITED WARRANTY
15
Need help? Call 1-800-620-2790 (U.S. and Canada)
RF-TVMLPT03V3
STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
1 Align the wall plate template (D) at the height you determined in the previous step and
make sure that it is level. Tape the wall plate template to the wall, then use a pencil to
mark the lag bolt hole locations (4). Remove the wall plate template.
2 Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter masonry drill
bit.
3 Insert the concrete wall anchors* into the pilot holes and use a hammer to make sure the
anchors are flush with the concrete surface.
4 Align the wall plate (A) with the anchors, insert the lag bolts (T) through the lag washers
(S) and the holes in the wall plate, then tighten the lag bolts only until they are firm
against the wall plate.
*Not included. Call Customer Service to have the Fischer UX10 x 60R concrete anchor kit
shipped directly to you.
You’ll need
CAUTION: To prevent property damage or personal injury, never drill
into mortar between blocks. Mount wall plate directly onto the
concrete surface.
CAUTION: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (T).
Lag bolt (T) (4)
Hammer
3/8" masonry
drill bit
Template (D)
Wall plate (A)
Top
Dessus
Parte superior
Top
Dessus
Parte superior
RF-TVMLPT03V2 Template • Gabarit • Plantilla
Note: For wood frame installations, use a stud nder to
locate wood studs rst.
Remarque : Pour une construction à ossature de bois,
localiser d'abord les montants en bois, à l'aide d'un
détecteur de montants.
Nota: para la instalación en construcciones de armazón
de madera, primero debe localizar las vigas de madera
con un localizador de vigas.
Need help deciding how high to mount your TV? Scan this QR code.
Besoin d'aide pour déterminer la hauteur de montage du téléviseur?
Numériser ce code QR.
¿Necesita ayuda para determinar la altura de montaje de su televisor?
Escanee este código QR.
V2 13-0197
Tools Needed
Outils nécessaires
Herramientas requeridas
S (4)
Concrete Anchor U (4)
1/2" socket
wrench
Level
Drill
Tape
Pencil