User Manual
Table Of Contents
- Contents
- Introduction
- IMPORTANT SAFETY INSTRUCTIONS
- Specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
- STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
- STEP 4 - Determine wall-mount location
- STEP 5 - Option 1: Installing on a wood stud wall
- STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 6 - Attach your TV to the wall mount
- STEP 7 - Adjusting the tilt angle
- Removing the TV from the wall mount
- LIFETIME LIMITED WARRANTY
13
Need help? Call 1-800-620-2790 (U.S. and Canada)
RF-TVMLPT03V3
STEP 5 - Option 1: Installing on a wood stud wall
1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2 Align the wall plate template (D) at the height you determined in the previous step and
make sure that it is level. Tape the wall plate template to the wall, then use a pencil to
mark the lag bolt hole locations (4) on the stud centers. Remove the wall plate template.
3 Drill pilot holes to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit.
4 Align the wall plate (A) with the pilot holes, insert the lag bolts (T) through the lag
washers (S) and the holes in the wall plate, then tighten the lag bolts only until they are
firm against the wall plate.
You’ll need
Note: Drywall covering the wall must not exceed 5/8" (16 mm).
CAUTION: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (T).
Edge-to edge
stud finder
Lag bolt (T) (4)
7/32" wood
drill bit
1/2" socket
wrench
Template (D)
Wall plate (A)
Top
Dessus
Parte superior
Top
Dessus
Parte superior
RF-TVMLPT03V2 Template • Gabarit • Plantilla
Note: For wood frame installations, use a stud nder to
locate wood studs rst.
Remarque : Pour une construction à ossature de bois,
localiser d'abord les montants en bois, à l'aide d'un
détecteur de montants.
Nota: para la instalación en construcciones de armazón
de madera, primero debe localizar las vigas de madera
con un localizador de vigas.
Need help deciding how high to mount your TV? Scan this QR code.
Besoin d'aide pour déterminer la hauteur de montage du téléviseur?
Numériser ce code QR.
¿Necesita ayuda para determinar la altura de montaje de su televisor?
Escanee este código QR.
V2 13-0197
Tools Needed
Outils nécessaires
Herramientas requeridas
S (4)
Pencil
Level
Drill
Tape