User Manual
Table Of Contents
- Contents
- Introduction
- IMPORTANT SAFETY INSTRUCTIONS
- Specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
- STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
- STEP 4 - Determine wall-mount location
- STEP 5 - Option 1: Installing on a wood stud wall
- STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 6 - Attach your TV to the wall mount
- STEP 7 - Adjusting the tilt angle
- Removing the TV from the wall mount
- LIFETIME LIMITED WARRANTY
10
Need help? Call 1-800-620-2790 (U.S. and Canada)
STEP 3 - Option 2: Attaching the mounting hardware to TVs with
irregular or obstructed backs
1 Align the TV brackets (B and C) with the screw holes on the back of the TV.
2 Place spacers (I or J) behind the TV brackets and the washers (G or H) over the holes in the
TV bracket, then insert the screws (F, L, P, Q, or R) through the washers, TV bracket, and
spacers. Make sure the brackets are level.
3 Tighten the screws until they are snug against the TV bracket. Do not over tighten.
You’ll need
G (4)
H (4)
F (4)
L (4)
P (4)
or
or
or
Screws
Washers
I (4)
(B and C) TV
Brackets
Q (4)
or
R (4)
J (4)
Phillips screwdriver
Level
R
OR
OR
OR
L