User guide

17RF-RBREC
Establishing communication
Rocketboost products form an audio network and each Rocketboost
wireless receiver can select the audio from any Rocketboost wireless
sender in the network.
Important
Every Rocketboost network must contain one hub device, which
helps devices join the network. The network can have only one hub,
which you can enable using the hub switch on the back of all
Rocketboost wireless senders and wireless sender/receivers.
The RF-RBREC is a wireless receiver and is not a hub device. To add
this wireless receiver to your Rocketboost network, you need to pair it
to your hub device.
Important: Hub devices must always have power for your network to operate. The hub
device can be in standby (power saving) mode, but must stay plugged in.
To establish communications:
1 If possible, bring your Rocketboost hub device and the new Rocketboost
wireless receiver into the same room.
2 Press the Power button on the Rocketboost hub device to turn it on.
3 Press the Power button on your Rocketboost wireless receiver to turn it
on.
4 Press and hold the on the Rocketboost hub device for more than three
seconds to put it into pairing mode. The power indicator starts blinking
rapidly and the unit will stay in pairing mode for 30 seconds.
5 Press and hold the on your Rocketboost wireless receiver for more
than three seconds to put it into pairing mode.
• When successfully paired, the power indicator LEDs on both products
will stop blinking and stay on.
• If pairing fails after 30 seconds, the power indicator LEDs will begin
flashing at a slower rate. If this occurs, repeat the above steps.
Power on
indicator
RF-RBREC_10-1328_MAN_V5.fm Page 17 Wednesday, November 9, 2011 8:40 AM