Instruction Manual

8
Front panel
# Feature
1
Standby LED Turns red when the receiver is in standby mode.
2
Power/Join
button
Press to turn the receiver on. Press and hold to initiate joining. Press
again to go to standby.
3
Power/Join
indicator
Lights solidly when the device is joined to a network. Blinks when the
device cannot find a network. Blinks quickly when joining a network.
4
BASS button Press to activate or deactivate Bass enhancement.
5
Bass indicator Lights when the bass enhancement is activated.
6
SOURCE indicator Lights when the receiver is receiving audio. If the light is not on, the
sender may be switched off.
7
SOURCE button Press to select the audio source. Each press will toggle to the next
audio source.
8
HD indicator Lights when the receiver is receiving HD audio signals. When HD is
on, audio quality (signal-to-noise ratio) is enhanced.
9
IR sensor window Receives the signal from the remote control.
10
VOLUME knob Controls the volume level.
TM
1
2
3
9
5
7
6
4
10
8
RF-RBREC_09-0475_MAN_ENG_V1.fm Page 8 Friday, August 28, 2009 6:20 AM