Instruction Manual

21RF-RBREC
Specifications
No
communicatio
n between the
sender and
receiver
• Make sure that the AC adapter is connected to the sender and the power cord is
connected to the receiver.
• Once the power-on buttons have been held to turn on both sender and receiver
and both units are in joining mode, the power-on indicators should blink quickly.
• If the power-on indicators on both units are solid on, then a communication link
has been successfully established between the units. If the power indicators on
both the units are blinking at a slower rate, press and hold the buttons on
either sender or receiver for three seconds. This will put the unit into joining mode
for about 30 seconds. During this time, press the button on the other unit for
three seconds, so that it will also enter joining mode. The system proceeds with
the connection process between the sender and receiver. During the joining
mode, the power indicators on both sender and receiver blink at a faster rate.
When an active link is established between the sender and receiver, the power-on
indicators on both units are solid on and do not flash.
Note: Try pressing the buttons again if the power indicators are blinking at a slower
rate after blinking fast for 30 seconds.
No response
when you press
any button
• Try disconnecting the main power to reset the device.
Connecting a
source device
• If your network is already full with transmitters when joining is attempted, the
Source LED will blink three times and then turn off. Remove (power down) a
transmitting device and try again.
Connecting a
device
• When you try to join a device to a network that has too many nodes, the device
will stay in joining mode until it times out (30 second timeout). Upon timeout the
unit should be on and will flash the power ring LED in a slow blink indicating it is
not connected to the network.
When trying to
change the
source on a
Rocketfish unit
the Power LED
flashes 5 times.
• Your RF-RBKIT sender is in four channel lock mode. By design, these channels are
not available for access by other receivers as they form the rears/surrounds of your
Home Theater system. If you do wish to use them, then you should remove the
four channel lock mode by moving the switch on the back of the sender to disable
four channel lock mode. Both sources will then be available for all receivers.
Audio input - wireless
Stereo, 16-bit, 48KHz, uncompressed Wireless audio system
performance Signal-to-Noise Ratio: 94dB (96dB in HD
mode).Total harmonic distortion: 1%
Audio output - high efficiency.
Class D, speaker level
Supports 4 to 8 ohm speakers Audio output power: 2x42W
(RMS) into 4 ohms
Transmission delay
15 to 20 ms
Problem Solution
RF-RBREC_09-0475_MAN_ENG_V1.fm Page 21 Friday, August 28, 2009 6:20 AM