Instruction Manual

Setting up your wireless receiver

Setting up your remote control

The remote control comes from the factory with an insulating plastic

tab which must be removed to enable the battery. Pull the tab out to

enable the battery on the remote control.

Replacing the remote control battery

To replace the battery:

1 Squeeze and pull to release the battery tray (1). You can remove the

battery tray (2) with your fingernails by using the spaces set back in the

remote control.

Next Source button Press to select the audio source. Each press toggles through all the

available sources on your network.

INPUT A Press to select between the audio source connecting SPEAKER Input A

or Pre-in A (only applies when you are using the sender in the

RF-RBKIT).

INPUT B Press to select between the audio source connecting SPEAKER Input B

or Pre-in B (only applies when you are using the sender in the

RF-RBKIT).

Volume buttons (stream)

Press to adjust the volume of all devices receiving the same audio

stream or tuned to a station.

(mute - all)

Press to mute all devices. Press a second time to unmute the stream

that was being listened too. This will unmute all nodes receiving that

stream, but if there are other transmitters sending streams then they

must be unmuted by pointing the remote at a device muted for that

particular stream.

# Feature

RF-RBREC_09-0475_MAN_ENG_V1.fm Page 10 Friday, August 28, 2009 6:20 AM