User Manual
Table Of Contents
14
Need help? Call 1-800-620-2790 (U.S. and Canada)
STEP 6 - Option 2: Installing on a solid concrete or concrete
block wall
CAUTION: To prevent property damage or personal injury, never drill into mortar
between blocks. Mount the wall plate directly onto the concrete surface.
Note: Minimum solid concrete thickness: 8 in (203 mm). Minimum concrete block
size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
1 Align the center of the wall plate template (11) at the height you determined in
the previous step and make sure that it is level. Tape the wall plate template to
the wall, then use a pencil to mark the lag bolt hole locations (2). Remove the
wall plate template.
2 Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter
masonry drill bit.
3 Insert the concrete wall anchors (refer to Concrete Installation Kit CMK1 (not
included) on page 4) into the pilot holes and use a hammer to make sure that the
anchors are flush with the concrete surface.
4 Align the wall plate (12) with the anchors, insert the lag bolts (C1) through the
holes in the wall plate assembly, then tighten the lag bolts only until they are
firm against the wall plate.
CAUTION: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (C1).
!
cure
d, simply pick-up
e w
all plate and lock
tab
ations!
You ’re done.
!
If you have questions
s
tome
r
G
T
E
P
3
GE
T S
TART
E
D
WIT
H
STEP
1
e
line them up
k
of
your
TV.
late to
roug
h.
c
k-up
all
plate
and lock tab
atulations!
Y
ou’re
done.
! If
you have question
s
omer
L
Y G
OING
TE
P
3
G
ET ST
ARTED
WIT
H
STEP
1
brac
T
V
.
t
3 in.
(75 mm)
3/8 in.
(10 mm)
RF-HTVMTAB_16-0417_MAN_V2_ENG.fm Page 14 Friday, June 3, 2016 2:41 PM