User Manual

12
Need help? Call 1-800-620-2790 (U.S. and Canada)
STEP 6 - Option 1: Installing on a wood stud wall
Note: Drywall covering the wall must not exceed 5/8" (16 mm).
1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2 Align the center of the wall plate template (13) at the height you determined in
the previous step and make sure that it is level. Tape the wall plate template to
the wall, then use a pencil to mark the lag bolt hole locations (2) on the stud
centers. Remove the wall plate template.
3 Drill pilot holes to a depth of 2 3/4 in. (69 mm) using a 7/32 in. (5.5 mm) diameter
drill bit.
Note: Minimum wood stud size: Common 2 x 4 in. (51 x 102 mm). Nominal 1.5 x 3.5 in. (38 x 89 mm)
4 Remove the cover caps to expose the mounting holes in the wall plate assembly
(14).
5 Align the wall plate assembly (14) with the pilot holes, insert the lag bolts (15)
through the holes in the wall plate assembly, then tighten the lag bolts only until
they are firm against the wall plate assembly.
CAUTION: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (15).
6 Replace the cover caps.
2 3/4 in.
(69 mm)
7/32 in.
5.5 mm)
Cover cap
Cover cap
Cover cap
Cover cap
RF-HTVMMAB_16-0210_MAN_V1_ENG.fm Page 12 Thursday, April 14, 2016 3:08 PM