User Manual
Table Of Contents
- Contents
- Introduction
- Specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the horizontal brackets to a TV with a flat back
- STEP 3 - Option 2: Attaching the horizontal brackets to a TV with irregular or obstructed back
- STEP 4 - Attaching the vertical bracket
- STEP 5 - Determine wall-mount location
- STEP 6 - Option 1: Installing on a wood stud wall
- STEP 6 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 7 - Attach the arm assembly to the wall plate
- STEP 8 - Attach your TV to the arm assembly
- STEP 9 - Managing cables
- STEP 10 - Adjust tilt
- STEP 10 - Adjust the level
- Removing your TV from the wall mount
- LIFETIME LIMITED WARRANTY
24
Need help? Call 1-800-620-2790 (U.S. and Canada)
STEP 9 - Managing cables
• Fully extend the arm assembly (11) to provide enough slack, then routing
cables along the arms and inserting them into the channels on the arms to
provide a clean look to your installation.
STEP 10 - Adjust tilt
Note: After your TV is in place, tighten the tilt tension knob to prevent unwanted
movement.
• Loosen the tension knob with your fingers or the hex key (14), adjust the tilt
angle, then tighten the knob to keep your TV in place.
11
14
Tension
knob