User Manual
Table Of Contents
- Contents
- Introduction
- Specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the horizontal brackets to a TV with a flat back
- STEP 3 - Option 2: Attaching the horizontal brackets to a TV with irregular or obstructed back
- STEP 4 - Attaching the vertical bracket
- STEP 5 - Determine wall-mount location
- STEP 6 - Option 1: Installing on a wood stud wall
- STEP 6 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 7 - Attach the arm assembly to the wall plate
- STEP 8 - Attach your TV to the arm assembly
- STEP 9 - Managing cables
- STEP 10 - Adjust tilt
- STEP 10 - Adjust the level
- Removing your TV from the wall mount
- LIFETIME LIMITED WARRANTY
17
Need help? Call 1-800-620-2790 (U.S. and Canada)
RF-HTLF23
STEP 6 - Option 2: Installing on a solid concrete or concrete
block wall
CAUTION: To prevent property damage or personal injury, never drill into the mortar between
the blocks. Mount the wall plate directly onto the concrete surface.
1 Align the center of the wall plate template (07) at the height you determined in
the previous step and make sure that it is level. Tape the template to the wall.
You’ll need
07
Note: Mount the wall plate (08)
directly onto the concrete surface (no
wall covering).
Minimum solid concrete thickness:
8in. (20.3 cm).
Minimum concrete block size:
8 × 8 × 16 in. (20.3 × 20.3 × 40.6 cm).
Minimum horizontal space between
fasteners: 16 in. (40.6 cm).
For concrete applications, the arm
assembly (11) must remain centered
in wall plate (08). Keep this in mind
when selecting the wall plate
location.
C1 Lag screw (4)
Drill
1/2" socket
wrench
07 Template (1)
Tape
08 Wall plate (1)
Level
Hammer
3/8" (10 mm)
masonry drill bit
C3 Concrete
anchors (04)
C2 Washer
(04)