User Manual

ManualsBrandsRocketFish ManualsConsolesRF-GDS1128 - Quick Setup Guide

Package contents

Extended USB power Screwdriver Quick

power shell cable Setup Guide

Features

Speci cations

• Additional battery capacity: 840 mAH (The additional battery is built into the

case.)

• Charging time: 4.5~5.0 hours (including original battery)

• Play time: up to 7 hours

RF-GDS1128

QUICK SETUP GUIDE

DSi Power Shell

Getting started

1 Use the included screwdriver to remove the two screws from the DSi’s

battery compartment, then remove the battery compartment cover and the

battery pack.

Notes: Screws are designed to stay connected to the console. Do not

misplace the screwdriver.

2 Insert the battery pack into the extended power case’s battery

compartment. Make sure that you insert the side with the battery contacts

 rst and  rmly press the battery into place.

3 Carefully place the DSi’s battery compartment door over the extended

power case’s battery compartment. Make sure the door’s screws are still held

in place. This allows you to safely store the battery compartment cover and

screws for later use.

Important: Store the screwdriver in the holder so you can use it to remove

the power shell later.

Upper case

Battery compartment

Screwdriver holder

Game drawer Stylus holder

Lower case

4 Carefully press the DSi console into the lower case.

5 Attach the upper case to the lower case, then carefully press the top of the

DSi console into the upper case.

Using the game storage drawer

• Open the game drawer, then insert a game cartridge into the drawer and

close it. The game cartridge  ts into the drawer when the cartridge’s metal

contacts are facing either the front or back of the case.

• To easily remove a game cartridge from the drawer, pull the drawer open

and turn the extended power case upside down. The game cartridge falls

out of the drawer.

Lower case

RF-GDS1128_10-0876_QSG_V1_EN.indd 1RF-GDS1128_10-0876_QSG_V1_EN.indd 1 9/3/2010 10:05:34 AM9/3/2010 10:05:34 AM

FINAL

FOR PRINT

Summary of content (2 pages)

PAGE 1
V1 FINAL FOR PRINT Getting started DSi Power Shell 4 Carefully press the DSi console into the lower case. 1 Use the included screwdriver to remove the two screws from the DSi’s battery compartment, then remove the battery compartment cover and the battery pack. Notes: Screws are designed to stay connected to the console. Do not misplace the screwdriver. Package contents Lower case 5 Attach the upper case to the lower case, then carefully press the top of the DSi console into the upper case.
PAGE 2
Storing the stylus Removing the DSi from the power shell: • Slide the stylus into the stylus holder on the right side of the case. 1 Carefully detach the upper case’s hinge tabs from the lower case, then remove the upper case from the DSi console. 4 Tighten the battery cover’s two screws. Recharging the battery 90-day limited warranty • Connect the included USB cable to the extended power case and to any powered USB port. Visit www.rocketfishproducts.com for details.