RF-HPL302_14-0333_MAN_V1_ENG.fm Page 1 Tuesday, April 22, 2014 2:39 PM Whole Home HD Extender RF-HPL302 User Guide Before using your new product, please read these instructions to prevent any damage.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 2 Tuesday, April 22, 2014 2:39 PM Rocketfish RF-HPL302 Whole Home HD Extender Contents Introduction............................................................................................. 2 Features..................................................................................................... 5 Set up your HD Extender ..................................................................11 Use your HD Extender......................................................
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 3 Tuesday, April 22, 2014 2:39 PM RF-HPL302 Safety information CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 4 Tuesday, April 22, 2014 2:39 PM 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 5 Tuesday, April 22, 2014 2:39 PM RF-HPL302 • Read the Rating Labels on the bottom of the Transmitter and Receiver for power input and other safety information.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 6 Tuesday, April 22, 2014 2:39 PM Transmitter Front panel # Item Description 1 2 Source indicators Light to show which input source is selected. Sync indicator If this indicator is off, the HD Extender Transmitter and Receiver have not established a connection. When they are connected, the indicator will blink according to the quality of the connection: as the connection quality improves, the indicator will blink slower.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 7 Tuesday, April 22, 2014 2:39 PM RF-HPL302 Back panel # Item Description 1 RESET button 2 HDMI INPUTS 3 4 5 6 HDMI OUT SERVICE port AC input IR OUT jack Press (with a pen tip or paperclip) to reset to factory default settings. Plug the HDMI cable from the source HD audio/video devices into these jacks. HDMI 1 is the default. Plug the HDMI cable from an HD TV into this jack. Service port, do not use. Plug the AC power cord into this jack.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 8 Tuesday, April 22, 2014 2:39 PM Receiver Front panel # Item 1 2 Source indicators Light to show which input source is selected. Sync indicator If this indicator is off, the HD Extender Transmitter and Receiver have not established a connection. When they are connected, the indicator will blink according to the quality of the connection: as the connection quality improves, the indicator will blink slower.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 9 Tuesday, April 22, 2014 2:39 PM RF-HPL302 Back panel # Item Description 1 RESET button 2 3 4 5 HDMI OUT SERVICE port AC input IR IN jack Press (with a pen tip or paperclip) to reset to factory default settings. Plug the HDMI cable from an HD TV into this jack. Service port, do not use. Plug the AC power cord into this jack. Plug the IR Receiver cable into this jack.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 10 Tuesday, April 22, 2014 2:39 PM Remote control # 1 2 3 10 Item (power) Source 1 Source 2 Description Press to turn on power to the Transmitter or Receiver. Press to switch to standby mode. Press to select the SOURCE 1 input. Press to select the SOURCE 2 input.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 11 Tuesday, April 22, 2014 2:39 PM RF-HPL302 Set up your HD Extender This unique technology allows you to connect a DVR, cable box, or other video device to another TV anywhere in your home! Connect the Transmitter to your video device(s) and TV, then connect the Receiver to another TV to extend your viewing environment.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 12 Tuesday, April 22, 2014 2:39 PM To set up your HD Extender: 1 Place your Transmitter near your DVR, cable box, or other video device. 2 Connect your video source devices' HDMI output to the Transmitter's HDMI IN 1 or HDMI IN 2 inputs. You do not have to connect video devices to both HDMI inputs. 3 If your TV is near your video sources, connect the TV's HDMI IN jack to the Transmitter's HDMI OUT jack.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 13 Tuesday, April 22, 2014 2:39 PM RF-HPL302 5 Place your Receiver near your TV. 6 Connect the Receiver's HDMI OUT jack to your TV's HDMI IN jack. 7 Press the Source/Input button on your TV's remote to select the correct HDMI input. 8 Plug the Receiver into AC power. After the receiver and transmitter are turned on, the Sync indicators blink while establishing a connection over the power line.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 14 Tuesday, April 22, 2014 2:39 PM Set up the IR emitter and IR receiver An IR receiver cable and an IR emitter cable are included, allowing you to control a video source, even when it's in another room. Just point your devices' remote control at the IR receiver instead of your video sources themselves. Transmitter Dual IR emitter cable Stick each emitter to the IR sensor on your video sources.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 15 Tuesday, April 22, 2014 2:39 PM RF-HPL302 1 Plug the IR emitter cable into the Transmitter. 2 The IR emitter cable has two separate IR emitters, one for each video source device you want to control. For each IR emitter, remove the protective cover from the tape on the emitter and stick the emitter near the IR sensors on your video sources. 3 Plug the IR receiver cable into the Receiver if your Receiver is out of view or hidden in a media cabinet.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 16 Tuesday, April 22, 2014 2:39 PM Notes: The Receiver and Transmitter will automatically turn on and off based on the power state of the TVs connected to the Receiver and Transmitter. • When the TV connected to the Transmitter is turned on, the Transmitter automatically turns on. • When the TV connected to the Transmitter is turned off, the Transmitter will automatically turn off after a few minutes if the TV connected to the Receiver is not turned on.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 17 Tuesday, April 22, 2014 2:39 PM RF-HPL302 Problem No picture on your TV or projector You can’t view different channels or video content Poor picture quality Intermittent or no sound The IR emitter will not control the source device Solution • Make sure that the connections are correct and secure between the Transmitter input and your HD device output. • Make sure that an HDMI input has been selected as the source on your TV or projector.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 18 Tuesday, April 22, 2014 2:39 PM Specifications Video CODEC Video Resolution Digital audio Power Line Link speed Power Consumption H.264 video encode and decode Support up to 1920 x 1080 @ 60p Dual channel, Linear PCM, 44.1 KHz, 48KHz 500 Mbps SmartLink PLC technology Standby - 4.2 W On - 6.0 W Legal notices FCC This device complies with Part 15 of the FCC Rules.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 19 Tuesday, April 22, 2014 2:39 PM RF-HPL302 turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and Receiver. -- Connect the equipment into an outlet on a circuit different from that to which the Receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.
RF-HPL302_14-0333_MAN_V1_ENG.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 21 Tuesday, April 22, 2014 2:39 PM RF-HPL302 One-Year Limited Warranty Rocketfish Products (“Rocketfish”) warrants to you, the original purchaser of this new RF-HPL302 (“Product”), that the Product shall be free of defects in the original manufacture of the material or workmanship for one (1) year from the purchase of the Product (“Warranty Period”).
RF-HPL302_14-0333_MAN_V1_ENG.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 23 Tuesday, April 22, 2014 2:39 PM RF-HPL302 Distributed by Best Buy Purchasing, LLC 7601 Penn Avenue South, Richfield, Minnesota, U.S.A. 55423-3645 © 2014 Best Buy Enterprise Services, Inc. All rights reserved. ROCKETFISH is a trademark of Best Buy Enterprise Services, Inc. Registered in some countries. All other products and brand names are trademarks of their respective owners.
RF-HPL302_14-0333_MAN_V1_ENG.fm Page 24 Tuesday, April 22, 2014 2:39 PM www.rocketfishproducts.com (800) 620-2790 Distributed by Best Buy Purchasing, LLC 7601 Penn Avenue South, Richfield, MN 55423-3645 USA © 2014 BBY Solutions, Inc. All rights reserved. ROCKETFISH is a trademark of BBY Solutions, Inc. All other products and brand names are trademarks of their respective owners.
