User Manual

11
Need help? Call 1-800-620-2790 (U.S. and Canada) or
01-800-926-3010 (Mexico)
RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C
3 Insert two anchors (H).
4 Install the wall plate using two screws (F). Tighten the screws only until they are
flush against the wall plate.
If needed, you can make small level adjustments to the wall plate, by loosening
the bottom screw and shifting the wall plate until level. Tighten the bottom
screw when adjustments are complete.
CAUTION
Be sure the anchors are seated flush with the concrete
surface.
CAUTION
Avoid potential personal injury or property damage!
Overtightening could reduce the holding power of the
screws. DO NOT over-tighten the screws.
You’ll need
1/4” (6.5 mm)
masonry drill bit
Hammer
Pencil
(H) Anchors
(2)
Drill
Phillips screwdriver
(F) Wall plate screw
(C) Wall plate
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 11 Monday, August 21, 2017 9:39 AM