RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 1 Monday, August 21, 2017 9:39 AM Multi-Directional Speaker Mount RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C For wood-stud, drywall, and concrete wall installations Safety information and specifications................................. 2 Tools needed ................................................................................ 3 Package contents: parts ...........................................................
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 2 Monday, August 21, 2017 9:39 AM Safety information and specifications IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS Compatible speakers: Sonos PLAY: 1 or PLAY 3, and other wireless speakers Maximum speaker weight: 10 lbs. (4.5 kg) Overall dimensions (H × W × D): 3.83 x 2 in. (9.73 x 5.08 cm) Wall-mount weight: 0.5 lbs. (0.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 3 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C Tools needed You will need the following tools to assemble your new speaker mount: Pencil Level Tape Phillips screwdriver Drill Wood stud installation Edge-to-edge stud finder 1/8” (3 mm) wood drill bit Concrete installation 1/4” (6.5 mm) masonry drill bit Hammer Drywall installation 1/4” (6.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 4 Monday, August 21, 2017 9:39 AM Package contents: parts Make sure that you have all the parts necessary to assemble your new speaker mount: The mount (A), cap (B), and wall plate (C) come already assembled. Push the cap off the mount, then slide the wall plate out to disassemble. A Mount (1) B Cap (1) D Bracket (1) C Wall plate (1) Package contents: hardware Make sure that you have all the hardware necessary to assemble your new speaker mount.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 5 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C Installation instructions STEP 1 - Select a mounting option You can mount your speaker to three wall types: • Option A: To mount to a wood stud wall, see “STEP 2 - Option A: Installing on a wood stud wall” on page 6. • Option B: To mount on drywall, see “STEP 2 - Option B: Installing on drywall“ on page 8.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 6 Monday, August 21, 2017 9:39 AM STEP 2 - Option A: Installing on a wood stud wall CAUTION • Drywall covering the wall must not exceed 5/8" (16 mm). • The wood stud must not be smaller than a nominal 2 x 4 in. (51 x 102 mm) actual 1-1/2 x 3-1/2 in. (38 x 89 mm) • Make sure that you drill at the center of the stud. 1 2 6 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 7 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C 3 4 Drill pilot holes to a depth of 1-3/4 in. (45 mm) using a 1/8 in. (3 mm) diameter drill bit. Make sure that you drill into the center of the stud. Attach the wall plate with the two wall plate screws (F). Tighten the screws only until they are flush against the wall plate.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 8 Monday, August 21, 2017 9:39 AM STEP 2 - Option B: Installing on drywall CAUTION Drywall covering the wall, must not be less than 1/2 in. (12.7 mm) 1 2 Make sure that the placement of the wall plate (C) is not on a stud. Position the wall plate at your desired height and level the wall plate, then mark the hole locations. Drill pilot holes to a depth of 1 in. (25 mm) using a 1/4 in. (6.5 mm) diameter drill bit. 1 in. (25 mm) 1/4 in. (6.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 9 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C 3 4 Install two anchors (H) into the holes making sure that they are flush with the drywall. Install the wall plate with the two wall plate screws. If needed, you can make small level adjustments to the wall plate, by loosening the bottom screw and shifting the wall plate until it is level. Tighten the bottom screw when adjustments are complete.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 10 Monday, August 21, 2017 9:39 AM STEP 2 - Option C: Installing on a solid concrete or concrete block wall CAUTION • Mount the wall plate directly onto the concrete surface (no wall covering). • Minimum solid concrete thickness: 8 in. (203 mm) • Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm) 1 2 Postion the wall plate (C) on the wall at your desired height. Level the wall plate and mark the hole locations.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 11 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C 3 Insert two anchors (H). CAUTION Be sure the anchors are seated flush with the concrete surface. 4 Install the wall plate using two screws (F). Tighten the screws only until they are flush against the wall plate. If needed, you can make small level adjustments to the wall plate, by loosening the bottom screw and shifting the wall plate until level.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 12 Monday, August 21, 2017 9:39 AM STEP 3 - Option A: Attach your Sonos PLAY:1 or other wireless speaker In addition to the Sonos PLAY:1 and PLAY:3, your speaker mount is compatible with other wireless speakers that use 1/4”-20 screws. Note: You can install your speaker right-side-up or up-side-down. • Attach the mount (A) to the speaker with the Play:1/Play:3 screw (G). Either hole on the mount can be used.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 13 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C STEP 3 - Option B: Attach your Sonos PLAY:3 speaker Note: You can mount your speaker vertically or horizontally. 1 Attach the interface bracket (D) to the mount (A) with the Play:3 interface screw (E).
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 14 Monday, August 21, 2017 9:39 AM 3 Secure the assembly to your Play:3 speaker with the Play:1/Play:3 speaker screw (G). Vertical Horizontal You’ll need Phillips screwdriver (G) Play:1 / Play:3 screw (A) Mount 14 (D) Bracket (E) Play:3 interface screw Need help? Call 1-800-620-2790 (U.S.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 15 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C Step 4 - Mount the assembly to the wall plate 1 Slide the speaker/wall mount assembly onto the wall plate (C). 2 Slide the cap (B) onto the mount (A). You’ll need (B) Cap (A) Mount Need help? Call 1-800-620-2790 (U.S.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 16 Monday, August 21, 2017 9:39 AM STEP 5- Adjusting the angle • You can rotate your mount left or right and tilt it up or down by hand to adjust the angle. Sonos Play:1 or other speakers 9° 66° 132° 27° Sonos Play:3 9° 30° 35° 70° 16 Need help? Call 1-800-620-2790 (U.S.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 17 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C Removing the speaker 1 2 Use a small screwdriver to loosen the cap (B) and slide it off the mount. Slide the speaker/wall mount assembly (A) up and off the wall plate (C). 3 Remove the Play:1/Play:3 speaker screw (G) to remove the mount (A) from your speaker.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 18 Monday, August 21, 2017 9:39 AM One-Year Limited Warranty Definitions: The Distributor* of Rocketfish branded products warrants to you, the original purchaser of this new Rocketfish-branded product (“Product”), that the Product shall be free of defects in the original manufacturer of the material or workmanship for a period of one (1) year from the date of your purchase of the Product (“Warranty Period”).
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 19 Monday, August 21, 2017 9:39 AM RF-HSWM1A18 / RF-HSWM1A18W / RF-HSWM1A18-C / RF-HSWM1A18W-C Where is the warranty valid? This warranty is valid only in the United States and Canada at Best Buy branded retail stores or websites to the original purchaser of the product in the county where the original purchase was made.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 20 Monday, August 21, 2017 9:39 AM REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS YOUR EXCLUSIVE REMEDY FOR BREACH OF WARRANTY. ROCKETFISH SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR THE BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT, INCLUDING, BUT NOT LIMITED TO, LOST DATA, LOSS OF USE OF YOUR PRODUCT, LOST BUSINESS OR LOST PROFITS.
RF-HSWM1A18(-C)_HSWM1A18W(-C)_17-0678_MAN_V3_ENG.fm Page 29 Monday, August 21, 2017 9:39 AM Part # 6907-302006 www.rocketfishproducts.com (800) 620-2790 (U.S. and Canada) or 01-800-926-3010 (México) ROCKETFISH is a trademark of Best Buy and its affiliated companies. Registered in some countries. Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2017 Best Buy. All rights reserved.
