User Manual

12
Operation steps below:
• Turn on the Launch controller.
• Connect the Launch controller to the computer via a USB data cable. Wait for
the LED ring breathes in red or green.
• Install driver from PC automatically, prompt box pops up after successful
installation. Then, the Launch controller works as a joystick human interface
device (AKA HID device) normally.
Note: The user needs to manually install the driver if the PC doesn't install
automatically or is installed incorrectly. DO NOT power on the Launch controller
first and connect it to the PC. The USB port is invalid in this situation.
7. Joystick Calibration:
The joystick data may offset after it has been used for some time (if the joystick is
hit by a physical). Users need to re-calibrate joysticks based on the following steps;
•
After powering on, press the “SETUP” button on the back of the remote-control
Launch controller, it hears two "Bee Bee" sounds, and a red LED flashes quickly
(two flashes each time), which means remote control Launch controller entered
calibration mode.
• Move throttle joystick and direction joystick to the middle position, press the
“SETUP” button again, wait until the buzzer beep three "Bee Bee Bee" sounds,
red LED light flashes quickly (two ashes each time), which indicates joystick data
has been acquired and enter into the boundary value calibration mode.
•
Slowly rotate the throttle and direction joystick twice around the boundary of
the joysticks (counter-clockwise /clockwise), then press the SETUP button again,
it hears a long ''Bee'' sound for about 3 seconds. And the red LED light stops.
Stage 1 Drone Kit Instruction Manual