User Manual

09
2. LED Indicator and Buzzer:
The LED ring indicates the working status of the Launch controller.
The buzzer will alarm three times, which indicates a low battery and needs to be
recharged.
3. Binding the Receiver:
There are the steps to make the launch controller enter binding status;
i. Power on the Launch controller and wait for its system to load completely. The
LED ring will be solid blue if done correctly.
ii. Press the “Bind” button on the back of the Launch controller to enter binding
status. The LED ring will be red and flash quickly.
iii. The LED ring will change to solid blue 5 seconds later when the Launch
controller exits binding status. If not bind successfully, repeat the process
above.
4. Switching Protocol:
Note: Switching internal protocol is only available for the Frsky version Launch
controller. Express LRS version can only switch to the external TX module.
The Frsky version could suppo 4 different internal protocols, including Frsky D16
FCC, Frsky D16 LBT, Frsky D8, and Futaba S-FHSS, it also supports. The protocol is
indicated by the flashing times of the LED when power is on, before the buzzer
alarms.
Stage 1 Drone Kit Instruction Manual