User Manual
Installation Instruction RSEI 123
WIRING HARNESS INSTALLATION
**Note: The same harness is used for the JK 4-door version **
The additional door sensors are NOT used for the 2-door version
Step Slider Wiring Diagram
Driver Side Wire Color Passenger Side Wire Color
Front Door Sensor Orange/Yellow Front Door Sensor Green/Gray
Driver LED Light Brown/Tan Passenger LED Light Pink/Tan
Driver Actuator Red/Black Passenger Actuator Red/Black
**WARNING**
REMOVE FUSE FROM WIRING HARNESS PRIOR TO INSTALLATION! CONNECTING
THE HARNESS TO THE POWER SOURCE WITH THE FUSE ATTACHED WILL SHORT
OUT THE WIRING HARNESS
NEVER ALLOW THE DOOR SENSOR TO COME INTO DIRECT CONTACT WITH THE
ACTUATING MAGNET. THIS WILL DESTROY THE SENSOR MAKING IT UNUSABLE
1. Roll the rear carpet back underneath the rear seat.
2. The supplied harness is the same for all Jeep applications (Note: You will have some plug connectors
that will not be used). It is important that you secure harness so it is neatly out of the way to avoid
and damage to the wires.
3. Lay the harness into position
4. Start with the electronic box, plug it into the harness and mount it under the seat on the passenger
side.