TJ FRONT BUMPER FB-F-100-TJ, FB-F-100-TJA INSTALLATION INSTRUCTION RSEI 104
Parts List 4- 7/16” x 1” Bolts 4- 7/16” Washers 4- 3/8” x 1” Hex Bolts with flange washer 6- 1/2” x 1” Button Head Bolts 1. Remove stock bumper 2. If necessary, remove sway bar disconnect to allow bumper to fit 3. Place bumper on the stock frame rails and line it up with the stock mounting points on top of frame rails 4. Attach bumper to the frame using the 3/8” hex bolts with flange washers at the mounting holes at the rear of the bumper. 5. Attach Stock recovery shackles-> a.
6. Attach Bull Bar to the bumper using two 7/16” x 1” bolts and washers on each side of the Bull Bar. 7. If desired, attach winch to the bumper using the holes on the bumper and the hardware provided with the winch *If any parts listed are missing or damaged please call Rock-Slide Engineering @ 435-752-4580 prior to installation Thank you for choosing Rock-Slide Engineering products. We value your business and welcome your feedback/suggestions.
