Instruction Manual

Installation Instruction RSEI 116

RIDGE FRONT BUMPER BULL BAR LIGHT KIT

AC-LK-100-1

PARTS LIST

QTY

DESCRIPTION

LED Light

Push Button Switch

20AMP Fuse

Fuse Holder

Ring Terminals

Spade Female Connectors

12ft Wire

Butt Connectors

*If any parts listed are missing or damaged

please call Rock-Slide Engineering @

435-752-4580 prior to installation

PAGE 1
RIDGE FRONT BUMPER BULL BAR LIGHT KIT AC-LK-100-1 PARTS LIST QTY DESCRIPTION 1 LED Light 1 Push Button Switch 1 20AMP Fuse 1 Fuse Holder 2 Ring Terminals 2 Spade Female Connectors 2 12ft Wire 4 Butt Connectors *If any parts listed are missing or damaged please call Rock-Slide Engineering @ 435-752-4580 prior to installation Installation Instruction RSEI 116
PAGE 2
INSTALLATION 1. You may want to pull a dummy wire through the bulbar to help you get the wires pulled. Feed the supplied white wire through the bottom of the Bull Bar and out the small rear hole in the underside of the top. There is a center hole in both ends of the Bull Bar designed for wires. The Bull Bar comes with a plastic plug in the wire hole to keep moisture out of the Bull Bar. If the Bull Bar is off the bumper, the plastic plug can be removed.
PAGE 3
4. Push the LED light into the hole until it snaps in. Do the same with the switch. 5. Route the black wire from the bumper to the battery. Keep the wire away from any moving parts. Use a butt connector to connect the black wire and the fuse box together. Use the white wire to ground to the battery using one ring terminal. Use the other ring terminal to connect the fuse box to the positive side of the battery. Thank you for choosing Rock-Slide Engineering products.