Owner's manual

Installation Instruction RSEI 106
• Remove the driver side dash panel and drill a 18mm hole in the panel to accommodate
the cutoff switch
• You can mount the cutoff switch in multiple positions. We recommend the dash
panel simply for the ease off access (see below)
• Mount the ground from the cutoff switch to a metal surface behind dash panel (below)
• Route the cutoff switch wires by running the POS+ and NEG- wires up the driver side
“A” pillar and plug them into the back of the cutoff switch
• Route the remaining POS+ and NEG- wires through the firewall on the driver’s side into
the engine compartment.
• Make sure there is NO INTERFERENCE with any of the pedal linkage under the
dash
• Route these wires along the firewall up to the battery compartment
• Secure the wires using the harness attached to the firewall
• Attach the NEG- to the NEG- side of the battery
• Attach the POS+ to the POS+ side of the battery
• Position the actuating magnets on the catch side of each door
• Make sure the actuating magnets are in perfect line with the sensors
• **DO NOT allow the magnet and sensor to come into direct contact. This
will destroy the sensor making it unusable**