Owner's manual

Installation Instruction RSEI 106
16) Lift the slider into its final position by inserting the 3 forks on the slider onto the 3 body
mount bolts and aligning it against the Jeep rocker face
17) Make sure the actuator wire is free from being pinched between the frame
18) Attach the slider to the rocker face using the 5/16” button head bolts & washers
19) Start from the center of the slider and work out towards the ends
20) Apply a small amount of anti-seize to the threads of each bolt
21) You will be using 5 bolts/washers per side
a) We recommend tightening the button heads by hand to prevent any damage to the head
of the bolt
22) Tighten the body mount bolts beneath the Jeep to fully secure the slider
23) Make sure the spacer is in between the body and the slider on the front body mount
24) The body mount bolts need to be SNUG to the Jeep frame but DO NOT OVER TIGHTEN the
body mount bolts. Over tightening these bolts could create a friction point causing the
slider to not operate optimally
25) Double check all bolts to verify components and hardware are installed correctly and
securely to the Jeep
***Please note: Expect some variance in parts that may require you to adjust the
tension of bolts to make parts fit correctly and properly. Once all parts are installed,
we suggest then fully tightening all bolts again to fit securely***
If you have any questions please contact Rock-Slide Engineering @ 435-752-4580
WIRING HARNESS INSTALL
Step Slider Wiring Diagram
Driver Side Wire Color Passenger Side Wire Color
Front Door Sensor Orange/Yellow Front Door Sensor Green/Gray
Rear Door Sensor Orange/Pink Door Sensor Blue/White
Driver LED Light Brown/Tan Passenger LED Light Pink/Tan
Driver Actuator Red/Black Passenger Actuator Red/Black