JEEP JK4 STEP SLIDER INSTALLATION BD-SS-100-JK4 Installation Instruction RSEI 106
PARTS LIST QTY 1 1 1 1 1 1 1 2 2 2 2 4 10 10 10 10 DESCRIPTION Drivers Side Slider Assembly Passenger Side Slider Assembly Wiring Harness and Fuse Double Sided Sticky Squares and Alcohol Pad Cut Off Switch Anti-Seize Packet Control Box Aluminum Spacers Large Washers Grip Tape Strips 130mm Bolts Actuating Magnets and Door Sensors 7/16” Washers Aluminum Nutserts 5/16” SS Button Head Bolts 5/16” Stainless Steel Washers *Optional: 2 LED Light Strips *If any parts listed are missing or damaged please call Roc
STEP SLIDER INSTALLATION 1) 2) 3) 4) Remove the stock rocker guards if equipped Remove the front body bolts on the driver and passenger side (under the front door) Loosen the rear body bolts (under rear passenger doors) DO NOT REMOVE THESE BOLTS! You will need these bolts to support the slider you are about to put into place on the Jeep REAR FRONT 5) Replace the front body bolts on the driver and passenger sides with the 130mm bolt, aluminum spacer, and large washer in same sequence as the picture below
7) Insert the 3 slider forks into the 3 body mount bolt slots a) The slider should fit tight to the Jeep’s rocker side 8) The top side of the slider should be at a flat 90 degree angle even with the front and rear wheel wells of the Jeep 9) Tighten all body mount bolts to help bring the slider into position on the Jeep 10) This will be the final position of the slider so verify it’s straight, level, even on both sides and you are satisfied with the slider’s layout 11) Carefully drill a 7/32’’ pilot hole int
16) Lift the slider into its final position by inserting the 3 forks on the slider onto the 3 body mount bolts and aligning it against the Jeep rocker face 17) Make sure the actuator wire is free from being pinched between the frame 18) Attach the slider to the rocker face using the 5/16” button head bolts & washers 19) Start from the center of the slider and work out towards the ends 20) Apply a small amount of anti-seize to the threads of each bolt 21) You will be using 5 bolts/washers per side a) We reco
**WARNING** REMOVE FUSE FROM WIRING HARNESS PRIOR TO INSTALLATION! CONNECTING THE HARNESS TO THE POWER SOURCE WITH THE FUSE ATTACHED WILL SHORT OUT THE WIRING HARNESS NEVER ALLOW THE DOOR SENSOR TO COME INTO DIRECT CONTACT WITH THE ACTUATING MAGNET.
• • • • • • • Route the actuator wire around the backside of the slider and plug the red/black connector into the slider • Actuator wire must be wired around the backside of slider so it’s protected from the elements and will not be severed off during off-road activity • Secure wires to minimize slack so they are protected.
• Remove the driver side dash panel and drill a 18mm hole in the panel to accommodate the cutoff switch • You can mount the cutoff switch in multiple positions.
• • • • • • • Once that proper placement is achieved we recommend using a permanent marker to outline the magnet on the door. Re-check all wires to make sure they are completely secure and free from coming into contact with any moving part to prevent system damage due to a cut wire Reinstall all internal plastic and carpet pieces that were removed. Make sure that all wires are tucked back and out of heavy traffic areas on the floor.
TROUBLE SHOOTING/FRICTION POINTS • The slider is powered by the Jeep’s battery when engine is off and powered by the Jeep’s engine while the vehicle is running. This will cause the slider to operate at different speeds depending on the Jeep engine is running or not.
