Manual

FIELD STRIPPING: DISASSEMBLY

1. Press the magazine release and remove the magazine. Pull

the slide back and check the chamber to ensure that the pistol

is unloaded and safe to handle.

2. Press the recoil spring plug with your thumb and rotate the

barrel bushing clockwise.

3. Slowly allow the plug and recoil spring assembly to move

fo'rward. Do not remove yet as this will keep the recoil spring

guide in place.

4. Pull slide back until the lug on the slide stop is opposite the

disassembly notch and push rounded end of pin of slide stop

found at right side of frame. Push inward and through the

frame to disengage slide stop from slide and frame.

5. Pull the slide forward on its guide rails in the frame. The

barrel, barrel bushing, recoil spring, recoil spring guide and

recoil spring plug will come out with it.

6. Remove the recoil spring guide and plUg from the slide.

7. Rotate the barrel bushing to the left as iar as it will go and pull

it ou tto the front.

8. Tilt the barrel link forward to remove the barrel through the

front of the slide.

9. Remove the firing pin by pressing it with a pin while pushing

the firing pin stop downwards at the same time and out of the

slide.

10. Pry the extractor with a pin by its groove out of the slide.