User Manual
Table Of Contents
- Introduction
- Starting Up
- Testing a Capillary Blood Sample
- Reviewing and Handling Data
- Reminders and Meter Settings
- Cleaning and Disinfecting the Meter and the Lancing Device
- Other Functions and Troubleshooting
- Symbols, Icons, Messages
- General Product Information
- Index
96
Reminders and Meter Settings
CoaguChek INRange User’s Manual
Beeper Volume
If the beeper is activated, the meter always
beeps when an action is taken, for example a
test strip is inserted or sufcient sample has
been applied.
The beeper volume can be set or deactivated.
However, in case of an error the meter will
always beep for safety reasons, even if you
have set the beeper function to Off. To set the
beeper volume:
1 Select Beeper Volume and press the
Enter button
to open the corresponding
menu.
The currently set volume is shown with a
green dot on the right side.
2 Use the Arrow up/down buttons
to
select the desired volume.
3 Press the Enter button
to conrm the
selection, which is now marked by the
green dot.
4 Press the Enter button
again to save the
selected volume.
Settings
Beeper Volume
Set Targets
Result Format
Display Brightness
Units
Time & Date
Beeper Volume
Medium
High
Off
Low
Save
DRAFT - CONFIDENTIAL