User Manual
Table Of Contents
- Introduction
- Starting Up
- Testing a Capillary Blood Sample
- Reviewing and Handling Data
- Reminders and Meter Settings
- Cleaning and Disinfecting the Meter and the Lancing Device
- Other Functions and Troubleshooting
- Symbols, Icons, Messages
- General Product Information
- Index
94
Reminders and Meter Settings
CoaguChek INRange User’s Manual
The current activation status is shown with a
green dot on the right side.
A newly set or edited target range is only
valid for tests performed after this setting
was done, and will not affect test results
already stored in memory.
5 Use the Arrow up/down buttons
to
select On or Off.
6 Press the Enter button
to conrm the
selection, which is now marked by the
green dot.
7 Press the Enter button
again to proceed
to the next step.
Set Targets
On
Off
Next
DRAFT - CONFIDENTIAL