User Manual
Table Of Contents
- Introduction
- Starting Up
- Testing a Capillary Blood Sample
- Reviewing and Handling Data
- Reminders and Meter Settings
- Cleaning and Disinfecting the Meter and the Lancing Device
- Other Functions and Troubleshooting
- Symbols, Icons, Messages
- General Product Information
- Index
33
Starting Up
CoaguChek INRange User’s Manual
Select the preferred coagulation unit (for
displaying a test result) as the last step of this
initial setup process. The currently active unit
is shown by a green dot.
11 Use the Arrow up/down buttons
to select your preferred unit. The newly
selected unit is highlighted.
12 Press the Enter button
to conrm the
selection, which is now marked by the
green dot.
13 Press the Enter button
again to save the
selected unit.
The initial setup is now nished, the meter
displays the Main Menu. For a complete
overview of setup options (including those
which are not part of the initial setup) see
chapter Meter settings starting on page 85.
If you wish to power off the meter after setup:
14 Press and hold the Enter button
until
the meter powers off.
Units
INR
%Q
Sec
Save
Main Menu
Test
17:03
Settings
Reminders
My Data
17 Sep 2015
Other
Sep
DRAFT - CONFIDENTIAL