Users Manual Part 2

417Initial configuration
Roche Diagnostics
cobas
®
pulse · Software version 01.03 · User Assistance · Publication version 1.0
• TLS enabled (FIPS approved mode)
[FIPS_APPROVED_MODE]
TLS used in FIPS approved mode.
i
The cobas pulse instrument uses a cryptographic
library which offers a "FIPS approved" mode.
For more information about the FIPS140-2 status
of cobas pulse, contact you Roche representative.
Dependencies
If the DMS TLS level configuration item is set to TLS
disabled or to TLS enabled (FIPS approved mode), the
DMS TLS certificate check configuration item must be
set accordingly.
Configuration
You configure the DMS TLS level configuration item
using the following:
• Data management system (e.g., cobas
®
infinity POC)
• Barcode (generated via cobas
®
infinity edge)
DMS TLS certificate
This configuration item specifies the certificate chain that
allows the validation of the DMS server certificate.
Allowed formats: PEM, PKCS#12. The file must be stored
as a Base64 encoded string.
The DMS TLS certificate configuration item may be
provided in pfx file format which can contain a set of
certificates.
If the KeyUsage extension is defined in the certificate
and security services other than certificate signing or
certificate revocation list signing are supported (e.g.,
encipher data), the instrument TLS library validates that
the digitalSignature bit is set in KeyUsage, otherwise the
certificate is not accepted (even if DMS TLS certificate
check is deactivated).
Item ID
DMS_TLS_CERTIFICATE
Available values/format
0-50000 characters (content must be Base64 encoded)
The cobas pulse instrument contains a pre-installed
Roche certificate chain.For further information about
certificate usage refer to the cobas pulse connectivity
guide.
10 Initial configuration