Installation Instructions

4. 24-hour reset button test: 24 hours after the start of Wireless 2.4 GHz
transmitter, the remote control and the buttons on the board can not be set, and
the reset button can only be set after pressing the reset button.
6. Inspection Rules
6.1.1 Exit Inspection Contents See 6.1-6.4
6.1.2 Exit inspection shall be carried out batch by batch according to
ANSI/ASQZ1.4-2003.
5.2 type inspection
6.2.1 When wireless 2.4 GHz transmitter has one of the following conditions,
it should be type checked:
A. Trial-formulation type identification of new or old products transferred to
factories;
B. When the design, process and material of the product have changed
significantly;
C. When production is suspended for more than eight months and put into
operation again;
D. Normally continuous production of products, once a year;
E. When the State Quality Supervision Authority puts forward the
requirements for type inspection.
6.2.2 When any item of Wireless 2.4 GHz transmitter in type inspection is
not qualified, double sampling should be taken from the same batch of products
and the unqualified items should be re-examined. If any item in the
reexamination is not qualified, the batch of products will not be qualified.
Unqualified products shall be re-submitted for testing after improvement or
repairs.
6.3 Check before acceptance
The orderer accepts the products according to the ex-factory inspection
items. In case of quality disputes, both the supplier and the demander review
the products according to the supply agreement.
7. Marking, packaging and storage
7.1 Marks, which should include trademarks
7.2 Packing
Battery switches should be properly packed for each factory
7.3 Keep in storage
Wireless 2.4 GHz transmitter (including the packed wireless 2.4 GHz
transmitter) should be stored in a well ventilated warehouse with a relative
humidity not exceeding 80% and no corrosive gas for 12 months.