Technical data
Installation, user and maintenance manual – AY Condensing line, AY series
63
6 INITIAL ACTIVATION AND MAINTENANCE
In this section you will nd the following information:
Indications required by the authorized Robur Technical Assistance Centre (TAC) •
in order to carry out the entire procedure of rst start-up of the appliance (see
Paragraph 6.1 PROCEDURE FOR INITIAL ACTIVATION → 63);
Indications regarding maintenance operations of the appliance (Paragraph 6.2 •
MAINTENANCE → 68): general information and warnings; general indications
regarding checks, controls and cleaning.
Instruction for the Robur TAC or gas type conversion (Paragraph 6.3 CHANGE OF •
GAS TYPE → 70).
Before proceeding with the operations described in this section, the installation techni-
cian concerned is invited to read Paragraph 2.1 WARNINGS → 7. in regard to switching
the appliance on and o, refer to Paragraph 3.1 START UP (AND SHUT DOWN) → 17. If
the appliance is connected to a DDC (and the DDC is in controller mode), for the pha-
ses of activation and deactivation of the appliance it is necessary to refer to the two
manuals dedicated to the DDC itself.
6.1 PROCEDURE FOR INITIAL ACTIVATION
The initial activation procedure is composed of the following (main) steps.
Step 1: Preliminary verication of plant compliance.
Step 2: verication/regulation of combustion parameters and rst ignition .
Step 3: regulation of plant operating parameters.
The entire procedure for the initial activation of the appliance must only carried out by
an authorised Robur Technical Assistance Centre (TAC). The product's guarantee may
be void if the procedure is not carried out by a Robur TAC.
On leaving the factory, the appliance is reliable and tested.
Step 1: Preliminary verication of plant compliance
The Robur TAC technician must:
check that the whole plant has been manufactured in accordance with its de-•
sign, following the instructions supplied by the manufacturer and respecting
current legislation. The design must have been drawn up by a qualied self-em-
ployed professional person.
Check personally that all of the connections (hydraulic/gas and electrical) of the •
appliance (and of the Direct Digital Controller, if connected to the appliance)
have been made correctly.
Check that the necessary conditions for plant compliance eectively exist (as •
per the declaration consigned to the user by the qualied rm that has carried
out installation of the appliance).
The Declaration of Compliance CERTIFIES that the plant conforms to current regula-
tions. This declaration is a compulsory document, and as such must be issued by law
to the owner by the qualied rm that has overseen the installation of the appliance.
Check that the water pressure and ow in the hydraulic circuit and the static gas •
supply network pressure are correct, as indicated by the manufacturer.
If all the conditions listed above exist, the TAC can proceed with the operations, perfor-
ming the "initial activation" of the appliance.