Technical data
8
request the assistance of professionally qualied personnel from a telephone far •
from the appliance.
The appliance has a sealed circuit that may be classied as a pressurised container, i.e.
with internal pressure higher than atmospheric pressure. The uids contained in its
sealed circuits are harmful if swallowed or inhaled, or if they come into contact with the
skin. Do not carry out any operation on the sealed circuits of the appliance or on the
valves present.
Packing items (plastic bags, polystyrene foam, nails, etc.) must be kept out of the reach of
children, as they represent potential sources of danger.
The electrical safety of this appliance is assured only when it is correctly connected to an
eective grounding system, as detailed in current electrical safety norms.
Installation and regulatory references
When the appliance arrives at the installation site, before beginning the stages required
to move it in order to position it on the site, perform a visual check to ascertain that there
are no evident signs of breakage or damage to the packaging or to the external panels,
which would be signs that damage occurred during transport.
Packing materials must be removed only after the appliance has been positioned on site.
After removing the packing materials, ensure that the appliance is intact and complete.
Installation of the appliance may only be carried out by rms that are qualied in accord-
ance with current legislation in the country of installation, i.e. by professionally qualied
personnel.
"Professionally qualied personnel" means personnel with specic technical competence
in the sector of heating/cooling plants and gas appliances.
Installation of the appliance must be carried out in compliance with current local and
national regulations regarding the design, installation and maintenance of heating and
cooling plants in accordance with the manufacturer's instructions.
In particular, current regulations regarding the following must be observed:
Gas equipment.•
Electrical equipment.•
Heating installations and heat pumps•
Every other standard and regulation that concerns the installation of equipment •
for summer and winter air conditioning using gas fuel.
The manufacturer does not accept any contractual or extra-contractual liability for any
damage caused by errors in installation and/or failure to observe the abovementioned
regulations and the instructions supplied by the manufacturer itself.
Once the appliance is installed
The rm that has undertaken the installation must provide the owner with a declara-
tion that the installation has been carried out in compliance with proper workmanship
practices, current national and local regulations, and the instructions supplied by Robur
S.p.A.
Before contacting your authorised Robur Technical Assistance Centre (TAC) for the initial
activation, the rm must ensure that: