Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 70
D can have a value from 0 to 15 according to the elements (chamfers/radii) that constitute the groove, and
their arrangement.
First element : can have a value 0-1 (0= Chamfer, 1= Radius)
Second element : can have a value 0-2 (0= Chamfer, 2= Radius)
Third element : can have a value 0-4 (0= Chamfer, 4= Radius)
Fourth element : can have a value 0-8 (0= Chamfer, 8= Radius)
Based on the sum of the elements the value of parameter D is calculated D (see figure 1).
F.. = Overmetal on bottom (vertical), radial value expressed in mm.
L.. = Overmetal on sides (horizontal), value expressed in mm.
NOTE: if only one of the variables is specified (F or L) , the other variable will be assigned the same
value. If they are omitted both will be considered null.
P.. = Depth of cut (must always be greater than 0). Value expressed in mm.
The distance between one block and another is equal to 0.2 mm.
If this value is omitted the groove is executed in one cut.
R.. = Specifies the number of grooves (cycle repetition); if omitted, default value is 1.
S.. = Specifies the centre distance for groove repetition. It can be omitted if only one groove is
programmed (R=1). The value is radial and expressed in mm and can be positive or
negative.