Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 69
A.. = Angle of groove high wall (in axis X positive direction)
B.. = Angle of groove low wall.
These angles are always positive and have a value from 0 to 89.999 degrees. When the
assigned value is 0 , this means the walls are horizontal.
C.. = Tool width, always positive value,(r radius and orientation T3 must be specified on table
offset as it’s automatically activated the radius compensation).
U/X.. = U width of groove, X last point of groove – specify one or the other - :
If U < 0 the groove machining takes place from top to bottom.
If U > 0 the groove machining takes place from bottom to top.
If X < of the start point value, machining takes place from top to bottom of the workpiece
(X negative direction).
If X > of the start point value, machining takes place from bottom to top of the workpiece
(X positive direction).
W/Z.. = W indicates the depth of the groove, Z indicates the groove bottom measurement
- specify one or the other - :
If W < 0 = concave groove to left (Z negative direction)
If W > 0 = concave groove to right(Z positive direction)
If Z < of X start point value = concave groove to left
If Z > of X start point value = concave groove to right
Y*.. = Linking radius or chamfer dimension 1 (upper external))
H*.. = Linking radius or chamfer dimension 2 (upper internal)
K*.. = Linking radius or chamfer dimension 3 (lower internal)
Q*.. = Linking radius or chamfer dimension 4 (lower external)
If Y,H,K,Q, are omitted, the cycle considers them as 0.
This means that they will be ignored when machining (sharp edge).
D.. = Defines the type of profile (if chamfer or radius) in points 1,2,3,4 (figure 1).
Bit 3 Bit 2 Bit 1 Bit 0
0/8 0/4 0/2 0/1 Binary example of number D
8 4 2 1