Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 3
PAGE PAR. CONTENTS
44 3.15 M134/M135 Precise stop
45 3.16 G List of main “G” preparatory functions
47 4.0 FIXED FANUC CYCLES
47 4.1 G71 Material removal by turning
53 4.2 G72 Material removal by facing
57 4.3 G73 Profile repetition
60 4.4 G70 Finishing cycle
63 4.5 G174 Radial grooves rough machining/pre-finishing cycle
67 4.6 G176 Axial grooves rough machining/pre-finishing cycle
72 4.7 G175/G177 Finishing cycle for radial/axial grooves
76 4.8 G76 Thread cutting cycle in several cuts
81 4.9 G83 Front drilling cycle
83 4.10 G84 Front tapping cycle
85 5.0 SUB-PROGRAMS / PARAMETRIC PROGRAMMING
85 5.1 M98 M99 Use of sub-programs
89 5.2 # Parametric programming
93 6.0 BACK SPINDLE MACHINING
93 6.1 Most important addresses used
94 6.2 M Auxiliary functions
95 6.3 Example of machining with back spindle
98 6.4 O9100 Workpiece change-over with parting off
101 6.5 O9101 Workpiece change-over with parting off without extraction
104 6.6 O9102 Workpiece change-over without parting off
106 7.0 AXIS C MACHINING AND MOTOR DRIVEN TOOLS
106 7.1 Motor driven tools
108 7.2 Motor driven tools reset
109 7.3 M37 Axis “C”
110 7.4 Programming in real co-ordinates
111 7.5 M20/M21 Use of spindle brake
112 7.6 G83 Front drilling cycle
115 7.7 G87 Radial drilling cycle