Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 165
OPT STOP (B10) By pressing this key, you can enable or disable execution of the optional stop during
machining. If this control is enabled, the machine will stop the machining process in the blocks of the
programme where the M1 function has been entered. By pressing the key START the machine will start
the machining process from the following block.
PRG STOP (B11) By pressing this key, you can enable or disable machining of the piece, except for the
M S T functions.
DRY RUN (B12) By pressing this key all machining processes are carried out at rapid speed.
PRG TEST (B13) This Key is not used
MPG X (C8) It enables the hand-wheel to move the X-axis manually
MPG Z (C9) It enables the hand-wheel to move the Z-axis manually
MPG C (C10) It enables the hand-wheel to move the C-axis manually
(C12) This allows you to use the M30 function in two different ways:
1) if this key is enabled M30 is equivalent to M99 (the programme will rewind and
restart)
2) if this key is disabled, M30 has the usual effect (STOP + programme rewinding +
guard release)
The aim is to have an alternative to the use of blocks preceded by slashes, enabling a complete
programme to perform both continuous machining and machining of a single piece, pressing one
key and without modifying the programme itself.
TEST LAMPS (C13) This key is used to check efficiency of the leds on the operator’s panel
SPDL DEC (D8) This key is used to reduce, by increments of 10%, the number of programmed
spindle revolutions, until a minimum of 50% is reached
SPDL 100 % (D9) This key is used to restore the number of revolutions programmed for the
current spindle (100%)
SPDL INC (D10) This key is used to increase, by increments of 10%, the number of programmed spindle
revolutions, until a maximum of 120% is reached
(D11) SPINDLE BRAKE By pressing this key, you can enable or disable the brake on the spindle. This
key is only enabled on machines equipped with the "C-AXIS" option.
RAPID LIMIT (D13) By pressing this key you can enable or disable the limit of the axes rapid movement,
setting a value equivalent to 20% of the maximum available value (axes potentiomenter is only enabled
below 20%).
Work feed is equivalent to the programmed feed. You can modify it by means of the axes potentiometer. If
this key is enabled, the led will start blinking.
CYCLE START (E1) By pressing this key, the active programme is started or the selected MDI block is
processed.
CYCLE STOP (E3) By pressing this key, the cycle is stopped together with the axes. By pressing cycle
start (E1), the cycle and the axes will start again.