Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 164
STEP X1 (A6) Incremental movement 1/1000
STEP X10 (A7) Incremental movement 1/100
N.B. By pressing STEP X1 (A6) and STEP X10 (A7) simultaneously, you can obtain incremental
movement 1/10
HOME (A8) Pressing this key, axes are positioned in the reference point (see paragraph 1.2).
TEACH (A9) This Key is not used
OFFSET MEASU (A10) This key is used to select the TOOL OFFSET mode and to move the arm of
the probe; it is only enabled if the AUTOMATIC PROBE option is active (in this case the probe is
MANUAL, and it is only used to display the status):
a) By pressing this key once, the E304 alarm will appear on the screen to verify that there are no
hindrances to the movement of the probe arm.
b) By pressing this key twice, you will move the arm until the MACHINING position is reached and
the OFFSET mode is automatically enabled. The OFFSET mode is automatically enabled in JOG
(the offset table appears on the screen and a blinking message will indicate that any pressure on
the probe will modify the active corrector) and the key led lights up.
c) By pressing this key one more time, the stationary position of the probe arm will be restored,
and the led turns off.
N.B. If the probe is MANUAL, the key will blink when the probe is manually led to machining
position. In this case the pressure on the probe arm will have no consequences.
?NC(A12) This key is used to disable alarms that do not require Resetting
?MC (A13) This key will blink any time there is a message. If an alarm has been issued, the key will
not blink and an ALM message will appear on the status line at the bottom of the screen.
+X (B2) This key allows you to move the X-axis in + dir
- X (D2) This key allows you to move the X-axis in - dir
+Z (C3) This key allows you to move the Z-axis in + dir
- Z (C1) This key allows you to move the Z-axis in - dir
IRVRS(C2) By pressing this key in conjunction with +X -X +Z -Z you can speed up the movement
of the selected axis
+ C (B4) This key allows you to move the C-axis in + dir
- C (D4) This key allows you to move the C-axis in - dir
+ T (B6) This key allows you to move the turret disk in + dir
- T (D6) This key allows you to move the turret disk in - dir
SINGL BLOCK (B8) By pressing this key, you can either enable or disable programme execution in a
single block. If this control is enabled, press the green key START to process each programme block.
BLOCK DELET (B9) By pressing this key, you can enable or disable execution of blocks preceded by a
slash (for example: / G0 X100 Z100 M5). If this control is enabled, the machine will not process blocks
with slashes.