Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 156
6 - Press the soft key ENTER
14.10 ENTRY OF TOOL ORIENTATION
Entry of tool orientation is required whenever radius offset is being used (G41, G42, G40). Once the tool
has been reset, follow this procedure:
1 - Press the key SETTING PAGE until the OFFSET window appears on the screen
2 - Press the soft key OFFSET
3 - Press the soft key GEOMET
4 – Place the cursor on T (Type of Orientation) of the desired corrector
5 – Enter the type of orientation (3, 2, 8 etc.)
6 - Press the soft key ENTER
Values to be entered depend on the type of tool used, as shown in the following drawing:
14.11 ENTRY OF CUTTER RADIUS
Entry of cutter radius is required whenever radius offset is being used (G41, G42, G40) and when milling
is performed in G112 or G107 mode. Once the tool has been reset, follow this procedure:
1 - Press the key SETTING PAGE until the OFFSET window appears on the screen
2 - Press the soft key OFFSET
3 - Press the soft key GEOMET
4 - Place the cursor on R of the desired corrector
5 - Enter the cutter radius (3, 5, 8 etc.)
6 - Press the soft key ENTER