Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 155
20 After the facing off of piece, move only with X axis staying on Z facing off co-ordinate
21 Stop the spindle with M5 and press EOB INSERT START
22 Press SETTING PAGE until compens.
23 Press soft key Compen
Press soft key GEOM
24 Position with the cursor on the corrector to reset
25 Edit Z followed by the desired value
26 Press MEASURE
To reset the other external tools repeat the proceeding closing as much as possible the diameter or the
rabbet previously turned.
NOTE if a tool of turret 1 on spindle 2 is reset, or viceversa, the eventual overmetal on Z axis is to set as
negative.
14.7 TOOL TABLE MANAGEMENT
Apart form tool reset, the tool table is also required to perform fine correction, to enter the radius of the
insert and the type of tool orientation
To access the tool table, follow this procedure:
1 - Press the key SETTING PAGE until the OFFSET window appears on the screen
14.8 TOOL FINE CORRECTION
Once the tool table has been accessed, follow this procedure:
1 - Press the soft key OFFSEET
2 - Press the soft key WEAR
3 – Position the cursor on the X or Z-axis of the desired corrector
4 – Type in the offset value (0.1 0.15 etc.)
5 - Press the soft key + ENTR
N.B. The maximum offset value for each storage is 1 mm; offset on the X-axis is diametrical.
14.9 ENTRY OF INSERT RADIUS
Entry of the insert radius is required if radius offset is being used (G41, G42, G40). Once the tool has
been reset, follow this procedure:
1 - Press the key SETTING PAGE until the OFFSET window appears on the screen
2 - Press the soft key OFFSET
3 - Press the soft key GEOMET
4 – Place the cursor on R of the desired corrector
5 – Type in the radius value (0.4, 0.8, 1.2 etc.)