Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 152
6 - Press the soft key FIN - BG
14.0 TOOL RESET
Tool reset can be carried out following two different procedures described in this manual or by means of a
tool-measuring probe in the machines equipped with this option.
14.1 MANUAL TOOL RESET
1 - Fix the rough piece on the chuck
2 - Press the key MDI MODE placed on the operator’s panel
3 - Press the key PROGRAM PAGE
4 - Enable the first external tool to be reset followed by its offset.
For example: G54; then press EOB INSERT START
5 - Activate the first tool for external to reset followed by the corrector
example: T101 and press EOB INSERT START
6 - Put the spindle in rotation.
Example: G97 S500 M4 and press EOB INSERT START
7 - Turn the piece with JOG Z- Z+ X- X+ controlling
with the potentiometer axes or using the hand-wheel after having selected it.
8 - After turning the piece move away only with Z axe
on the x co-ordinate of turning.
9 - Stop the spindle writing M5 and press EOB INSERT START
10- MEASURE THE DIAMETER TURNED
11- Press the soft key PAGE SETTING till compens.
12- Press the soft key COMPEN
13- Press the soft key GEOMET
14- Place the cursor on the offset to be reset
15- Type in X followed by the measured value (for ex. X100.3)
16- Press the soft key MEASURE
17- Restart spindle rotation.
For example: G97 S500 M4 then press EOB INSERT START
18- Face the piece by means of the keys JOG Z- Z+ X- X+ controlling it with the axes potentiometer
or using a hand-wheel, after selecting it.
19- Once the piece has been faced, move away the X-axis only, keeping the same Z facing co-ordinate
20- Stop the spindle by typing in M5 then press EOB INSERT START
21- Press the key SETTING PAGE until the OFFSET window is reached
22- Press the soft key COMPEN
23- Press the soft key GEOMET