Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 147
13.0 PROGRAMME MANAGEMENT
This chapter describes management of machining programmes. Management includes
insertion, change and deletion of programme blocks as well as deletion, copying and
renaming of programmes.
13.1 HOW TO CREATE A NEW PROGRAMME
To create a new programme, follow this procedure:
1 - Select EDIT MODE on the operator’s panel
2 - Press PROGRAMME PAGE
3 - Type in the code O followed by the desired number from 1 to 8000
4 - Press the key INSERT then press the key EOB
5 - Insert the whole programme by pressing the key EOB at the end of each block and the key INSERT to
store all entered blocks.
N.B. Spaces are not required between two codes of the programme.
13.2 HOW TO MODIFY AN EXISTING PROGRAM
To modify an existing programme, follow this procedure:
1 - Select EDIT MODE on the operator’s panel
2 - Press PROGRAMME PAGE
3 - Type in the code O followed by the desired number (for ex. O8000)
4 - Press the soft key RECE O
13.3 HOW TO INSERT A CODE (OR A BLOCK) IN A PROGRAM
To insert a code (or a block) in a programme, follow this procedure:
1 - By means of the arrow keys, position the cursor on the previous code (if a whole block is being
inserted, position the cursor on the ; “semicolon” of the previous block).
2 - Type in the code to be entered.
3 - Press the key INSERT (or EOB and INSERT to insert a whole block)
13.4 HOW TO MODIFY OR REPLACE A CODE
To replace or modify a code in a programme, follow this procedure:
1 - By means of the arrow keys, position the cursor on the code to be replaced.
2 - Type in the new code.
3 - Press the key MODIFY