Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 114
Codes Q, P and R , if not used, need not be written.
This cycle can be used with chip breakage or undercutting, depending on the value of parameter 5101 bit
2 (if it is 0 chip breakage, if it is 1 chip undercutting) by default this bit is set to 1 for chip undercutting.
Parameter 5114 determines:
- in the case of chip undercutting, the distance at which the bit must stop in relation to the last point
reached when re-entering the hole after undercutting.
- in the case of chip breaking, how much the bit must back off between one cut and the next for drilling