Specifications

_____________________________________________________________________
_____________________________________________________________________
CONCISE GUIDE FANUC 100
It is also possible to recover any backlash caused by the use of double cone collet chucks, by inserting a
value in mm from 0 to 1 in “R” , which is recovered before parting off with the bar gripped between the two
spindles.
Separation takes place first along axis X at the value defined in variable “X” then axes B and Z
simultaneously at the values at which turret rotation took place.
The spindle synchronism is disabled, the main spindle rotation is stopped and a rotation of about 500
rpm is set for the back spindle which remains active when coming out of the sub-program.
At the end of this cycle the workpiece will be removed from the main spindle at the starting value, so that
this is ready to start work on a new part.