User`s guide

ACF60-00 – Installation, User’s and Maintenance Manual
36 Ed. 04/2012
1. appears on the display: press the knob to access the menu. The display
shows option 0 first, .
2. Press the knob and the reset request will begin flashing: .
3. Press the knob again to reset the flame control unit: The reset request stops flashing
and will again appear on the display. The resetting operation is now
finished.
4. To exit the menu, turn the knob in a clockwise direction until appears, then
press the knob to return to the selection menu: .
5. To exit the selection menu and return to the normal displaying of the ACF
parameters, turn the knob in a clockwise direction until appears, then
press the knob to exit.
Option 1: resetting of other ACF errors; this is used to reset any warnings or errors that
may arise during ACF operation.
Requirements: Accessibility to the electrical panel , see “Display and Knob
(encoder)”, page 32.
To reset circuit board errors, go to menu 2 as described in “Access to the circuit board
menu’s” on page 34, then:
1. appears on the display: press the knob to access the menu. The display
shows option 0 first, .
2. Turn the knob in a clockwise direction until option 1 appears, .
3. Press the knob and the reset request will begin flashing: .
4. Press the knob again to reset the circuit board errors. The reset request stops
flashing and will again appear on the display. The resetting operation is
now finished.
5. To exit the menu, turn the knob in a clockwise direction until appears, then
press the knob to return to the selection menu: .
6. To exit the selection menu and return to the normal displaying of the ACF
parameters, turn the knob in a clockwise direction until appears, then
press the knob to exit.