User`s guide

Section END USER
Ed. 04/2012 33
Requirements: Installed and running ACF.
To use the knob:
1. Remove the front panel by unscrewing the fastening screws.
2. Remove the special wrench from the tube above the electrical panel.
3. Remove the plug from the electrical panel to access the knob.
4. Through the hole, turn the knob using the special wrench.
The knob on the electrical circuit board can be turned using the special wrench without
opening the cover of the electrical panel, so that one can work safely without being
exposed to the electrical components.
When the necessary settings have been made, put the special wrench back where
it came from, replace the plug in the electrical panel and remount the front cover of
the ACF chiller.