Technical data

30
Set the room thermostat to its minimum.•
The burner will go out, whereas the fan will continue running so long as the appliance is
still warm.
Do not switch off the appliance by shutting off its power supply as this can severely dam-
age it by stopping the fan and tripping the limit thermostat (automatic reset).
The limit thermostat ONLY trips during malfunctions. Before resetting it, troubleshoot the
problem (in this case, overheating). If it trips frequently, contact ROBUR TAC.
SUMMER MODE
To activate FAN ONLY mode, proceed as follows:
You will need: the appliance connected to the power/gas supply.
Close the gas valve and check that the appliance is powered up.1.
Set button "A" (summer/winter button) to 2. Summer ("sun" ICON; detail "2" - Figure
4.1 → 29): this runs only the fan, to refresh the air in the room.
PROLONGED PERIODS OF DISUSE
If the appliance is put out of service for a LONG TIME (i.e., seasonal disuse), proceed as
follows:
Switch the appliance off and wait for the fan to stop running.•
Close the gas cock upline of the appliance.•
If you have no intention of using SUMMER mode, switch off the power supply to •
the appliance with the master power switch on the power cable.
SWITCHING THE APPLIANCE BACK ON: after a long period of disuse, it may be neces-
sary to start up the appliance several times, due to air in the tubes.