Instructions

9595
www.cel-robox.com
7.0 Calibration and Maintenance
7.3 Troubleshooting
This section of the user manual is intended to help you diagnose and fix a wide
range of issues you could be experiencing with your Robox®.
Problem / Symptoms Solution(s)
Hardware - My Robox® won’t turn
on - is it dead!?
Robox® will ‘play dead’ unless the
AutoMaker™ soware is running. Also ensure
the USB cable is connected, the power
switch on the rear of the unit is in the ‘On’
position, and the fuse in the plug is intact. If
you are still experiencing problems, please
contact CEL support.
Hardware - I’m having trouble
getting the first layer of my print to
stick to the print bed.
There are a number of possible causes and
solutions:
1. Try cleaning your print bed using the
supplied bed cleaning wipes, or a clean cloth
soaked in Isopropyl Alcohol.
2. There could be a problem with the
automatic bed-levelling system - try running
the ‘Level Gantry’ calibration.
Hardware - My motors/bearings are
making a ‘grinding’ sound as the
print head moves around the build
area.
It sounds like you need to perform some
maintenance, try lubricating the drive
screws and motion rails using the supplied
Axis Lubricant. See section 7.2.8 for more
information on maintenance procedures.