Instructions

8989
www.cel-robox.com
7.0 Calibration and Maintenance
On the illustration above, the output from the fill nozzle is shown in black, with
the fine nozzle shown in blue. Once the print has finished, DO NOT remove the
part, as the process is not yet complete. If the print didn’t complete successfully,
you can click the Retry Print button on the toolbar.
Compare the part on the bed to the image on-screen - you are looking for the
best alignment between the output from each nozzle (fill and fine) in the X and
Y axes. There are diagrams on the right which show the points you are looking
for. Then choose the appropriate number and letter for the profiles with the best
alignment and click Next to continue.