Instructions
6868
www.cel-robox.com
5.0 AutoMaker Soware
• Perimeter Nozzle Selection
This setting allows you to choose which nozzle is used to print the exterior
surfaces (perimeters) of the part - choose from 0.3mm (fine nozzle) or 0.8mm
(fill nozzle).
• Fill Nozzle Selection
This setting allows you to choose which nozzle is used to print the internal
filling of the part - choose from 0.3mm (fine nozzle) or 0.8mm (fill nozzle).
• Support Nozzle Selection
This setting allows you to choose which nozzle is used to print support
material around the part - choose from 0.3mm (fine nozzle) or 0.8mm (fill
nozzle).
• Support Interface Nozzle Selection
This setting allows you to choose which nozzle is used to print support
interface layers i.e. those between the build and support material - choose
from 0.3mm (fine nozzle) or 0.8mm (fill nozzle).
• Fine Nozzle Settings (0.3mm)
This switches the settings below to apply to the fine nozzle (0.3mm).
• Fill Nozzle Settings (0.8mm)
This switches the settings below to apply to the fill nozzle (0.8mm).
• Ejection Volume (mm³)
This parameter specifies the volume of material that is ejected as the needle
valve closes. The needle itself has a volume, and therefore displaces its
equivalent volume of plastic as the valve closes.
• Wipe Volume (mm³)
This parameter specifies how much material is le inside the tip of the nozzle
once the needle valve has closed. The ‘wipe’ is used to drag this last bit of
material over already printed material to fully drain the nozzle.
• Partial Open Value
This value can be used to specify a smaller needle movement as a ratio i.e. a
value of 0.5 will cause the needle valve to only open halfway.