Instructions

6565

www.cel-robox.com

5.0 AutoMaker Soware

• Layer Height (mm)

This setting defines the layer height (essentially the print resolution) of

the printed object. Users can select from any value between 20-400µm,

however this setting will dramatically aect print time as shown in the below

illustration:

Representation

(1.6mm Total Height)

Layer Height 400µm 200µm 40µm 20µm

Number of Layers 4 8 40 80

Total Print Time 8 mins 16 mins 1hr 20mins 2hrs 40mins

Also apparent from this diagram is the improved surface finish that will

be acheived as layer height is decreased - notice the reduction in the

appearance of the ‘stair stepping’ eect.

• Fill Density (%)

This setting changes the amount of material which is used to fill the interior

of the object. 100% signifies a completely solid object, and 0% is hollow.

• Fill Pattern

This setting is used to change the pattern of the extrusion used to fill the

interior of the part. There are 7 dierent options to choose from:

Line Rectilinear Honeycomb Concentric Archimedean

Chords

Octagram

Spiral

Hilbert Curve

• Infill Every n Layers

This setting forces Robox® to add a solid infill layer every n layers. To disable

this option, enter 0.

• Top and Bottom Layers

This setting specifies how many solid layers will be used to complete the

top and bottom of the object. You may need to increase this setting if you

are printing an object with a top or bottom surface which tends towards

horizontal to avoid gaps in the outer surface.