Instructions

5656
www.cel-robox.com
5.0 AutoMaker Soware
5.5 Settings Screen
This section explains the basic settings page of the soware which allows you to
choose quality options and materials for your print.
1 Filament Settings 5 Start the production (Make!)
2 Print Settings 6 Return to Status Screen
3 Advanced Settings 7 Model Display
4 Return to Layout Screen
5.5.1 Starting Production
To start a print, simply choose a quality setting from the Print Settings box (2),
verify that your material has been selected in the Filament Settings box (1), and
press Make! (5).
AutoMaker™ will then begin to slice your 3D model and transfer to your Robox®
ready for printing. Due to the unstable nature of printing ‘by wire’ - sending data
over USB during a print, Robox® incorporates onboard flash storage for storing
print jobs once production has started. This means that when the print job
has been fully transferred, you can disconnect from the USB, and Robox® will
continue to print unattached.
1
2
4 5
6
7
3